NG Solution Team
Comparison

Rhino Hitch Review: Adjustable UTV Hitch and Safe Loading

Lynn R. Blamires, who has used a Rhino Hitch for seven years, highlights the Utah-based adjustable coupler as a practical solution for towing multiple trailers and improving UTV loading safety. The Rhino Hitch offers a nine-inch height range and a rotating assembly that can be adjusted while attached, allowing users to level trailers quickly before hooking up chains and power.

Rhino Hitch features and setup

The Rhino Hitch is made of high-grade 6061 billet aluminum and assembled with industrial-strength bolts. Its whole assembly rotates for height adjustment by removing a pin; using a trailer jack, the ball can be set to level the trailer, the pin reinserted, and the trailer chains and electrical connection completed. Clint Hedberg, who leads marketing for the Rhino Hitch, showed Blamires a rocker arm from the hitch assembly that failed only after a stress test reached 50,000 pounds of pressure.

Blamires notes other adjustable hitches exist but none he has seen allow trailer-height adjustment to pull level while still attached. Pulling a trailer level is a basic safe towing practice, and the Rhino Hitch simplifies that task for users who tow different trailers.

The reviewer hauls two trailers — a 5×12-foot single-axle and a 7×22-foot double-axle UTV trailer — and says each requires a different hitch height to tow with a level bed. With a two-inch receiver on his Ford Expedition, Blamires uses the Rhino Hitch model that includes two balls, 2″ and 2 5/16″. Switching balls is done by moving a pin to the side that holds the ball, pulling it out, replacing the ball and centering the pin. The Rhino Hitch can be set for the larger trailer and adjusted lower for the smaller trailer so both tow parallel to the ground.

Brakes, gain settings and balance

Blamires stresses that a strong adjustable hitch is only part of safe towing. His smaller trailer lacks brakes while the larger trailer has them; he says he did not initially understand the gain settings on the trailer braking system and now resets gain according to trailer load so the trailer brakes and the truck’s brakes operate at peak efficiency. Proper load balance also affects braking and handling: too much weight forward increases tongue load and affects braking and handling, while too much weight toward the rear can cause the trailer to fishtail.

Safe UTV loading practices

Blamires lists practical steps for safe UTV loading:
– Check the truck’s towing capacity: the combined weight of trailer and load should be 2,000 to 3,000 pounds below the truck’s towing capacity. Pulling an overloaded trailer for long distances is a risk.
– Load on level ground to prevent the UTV from rolling sideways or tipping on the ramp.
– Secure the trailer and truck: lock the trailer coupler onto the hitch ball, connect the safety chains in a cross pattern, plug in the electrical harness and secure the ramps. Set the emergency brake on the truck and put the transmission in neutral to prevent transmission damage while loading; Blamires notes UTVs are getting heavier and not using the emergency brake will cause the transmission to handle jostling during loading.
– Use a spotter to ensure UTV tires are centered side to side and the load is balanced. Follow the 60/40 rule by placing about 60 percent of the weight slightly ahead of the axle; too much weight behind the axle causes trailer sway. Once positioned, put the transmission in park and apply the parking brake, if equipped.
– Secure the UTV with heavy-duty straps; Blamires prefers ShockStraps with the stretchable bone. Do not rely on the winch, which can kink or snap the line or damage the winch. Attach straps to the lower A-arms or frame tie-down points instead of upper suspension points, pulling front straps forward and rear straps backward to low points on the trailer.

When heading into the backcountry, Blamires recommends taking plenty of water, keeping the rubber side down and learning what it takes to arrive at the trailhead safely. He also points readers to the Rhino Hitch website at www.rhinohitch.com for more information. The Salt Lake Off-Road Expo at the Mountain America Exposition Center is coming up in March, where new OHV products including the Rhino Hitch are showcased.

Lynn R. Blamires can be reached at quadmanone@gmail.com.

Related posts

R.A.V.E. Strut Review: Power Hawk’s Rapid Stabilization Tool

David Jones

Thinkware U3000 Pro dash cam review: flagship dual-camera

James Smith

Trustpilot Expands AI Discovery with Product Review Pages

David Jones

This website uses cookies to improve your experience. We assume you agree, but you can opt out if you wish. Accept More Info

Privacy & Cookies Policy